WALKER SEALS

It is split in construction. Commonly used when dismantling is time consuming. The 'Walker' Type Oil Seal is extremely useful in this type of application because the outer edge is made of canvas reinforced rubber which can be split. The general application of this type of seal is in retaining lubricants in roll necks of millrolls, bearing etc.

The sealing lip is made of 'nitrile' synthetic rubber and is spring loaded for 'following' the rotating shaft under

various bearing conditions. The lip flexibility is maintained by accurate design without resorting to high degree of spring tension and thus reducing wear on both seal lip and the shaft.

Walker seals for rotary applications are extensively proven for long term bearing protection on plant as diverse as rolling mills, gearboxes, marine propulsion systems, process mixers and tunnel boring machines.

ADVANTAGES:

- Minimal heat generation and shaft wear.
- Flexible lip to accommodate shaft eccentricity.
- Highly cost effective
- Available in unlimited sizes
- Easy to install and simple to remove

HT ID OD Part No
11 50 75 100 050 07500 110
11 55 80 100 055 08000 110
8 60 70 100 060 07000 080
10 60 80 100 060 08000 100
11 60 85 100 060 08500 110
11 65 90 100 065 09000 110
10 68 84 100 068 08400 100
12.5 70 102 100 070 10200 125
12.5 75 107 100 075 10700 125
12 80 105 100 080 10500 120